HP LaserJet M1005 MFP - Reducing or enlarging copies

HP LaserJet M1005 MFP - Reducing or enlarging copies

Adjusting the copy size
Copying multiple pages on one sheet of paper
The device can reduce copies to as little as 25% of the original size or enlarge copies to as much as 400% of the original size.
Reduction/enlargement settings
  • Original=100%
  • A4 > Ltr=94%
  • Ltr > A4=97%
  • Full page=91%
  • 2 pages/sheet
  • 4 pages/sheet
  • Custom: 25-400%
NOTE:
For information about using the 2 pages/sheet or 4 pages/sheet setting, see .

Adjusting the copy size

To reduce or enlarge copies for the current job
  1. On the device control panel, press More Copy Settings.
  2. Use the < or the > button to select Reduce/Enlarge, and then press Menu/Enter.
  3. Use the < or the > button to select the size to which you would like to reduce or enlarge the copies in this job.
    NOTE:
    If you select Custom: 25-400%, use the < or the > button to adjust the percentage.
  4. Press Start Copy to save the selection and immediately start the copy job, or press Menu/Enter to save the selection without starting the job.
NOTE:
The change in the setting remains active for about two minutes after the copy job has been completed. During this time, Settings=Custom appears on the device control-panel display.
You must change the default media size in the media input tray to match the output size, or part of your copy might be cut off.
To adjust the default copy size
NOTE:
The default copy size is the size to which copies are normally reduced or enlarged. If you keep the factory default size setting of Original=100%, all copies will be the same size as the original document.
  1. On the device control panel, press Menu/Enter.
  2. Use the < or the > button to select Copy setup, and then press Menu/Enter.
  3. Use the < or the > button to select Def. Reduce/Enlrg, and then press Menu/Enter.
  4. Use the < or the > button to select the option for how you normally want to reduce or enlarge copies.
    NOTE:
    If you select Custom: 25-400%, type in the percentage of the original size that you normally want for copies.
    If you select 2 pages/sheet or 4 pages/sheet, select the orientation (portrait or landscape).
  5. Press Menu/Enter to save the selection.

Copying multiple pages on one sheet of paper

  1. On the device control panel, press More Copy Settings.
  2. Use the < or the > button to select Reduce/Enlarge, and then press Menu/Enter.
  3. Use the < or the > button to select 2 pages/sheet or 4 pages/sheet, and then press Menu/Enter.
  4. Use the < or the > button to select Portrait or Landscape, and then press Start Copy.
  5. Wait for the scanner to stop scanning. The Next Page [OK] to Continue message appears.
  6. Remove the original from the flatbed scanner, put the next original onto the scanner, and then close the lid.
  7. Press OK.
    • If you selected 2 pages/sheet, the device prints the copy with two original pages on one page.
    • If you selected 4 pages/sheet, repeat steps 6 and 7 two more times. The device prints the copy with four original pages on one page
NOTE:
The change in the setting remains active for about two minutes after the copy job has been completed. During this time, Settings=Custom appears on the device control-panel display.
You must change the default media size in the media input tray to match the output size, or part of your copy might be cut off.

https://support.hp.com/

Comments

Post a Comment